Based on TIA/EIA-568-B.1-2001, the T568A and T568B wiring schemes define the pinout, or order of connections, for wires in eight-pin modular connector plugs and jacks.
The only difference between T568A and T568B is that pairs 2 and 3 (orange and green) are swapped. Both configurations wire the pins "straight through", i.e., pins 1 through 8 on one end are connected to pins 1 through 8 on the other end, and the same sets of pins are paired in both configurations: pins 1 and 2 form a pair, as do 3 and 6, 4 and 5 and 7 and 8.
Cables that are terminated with differing standards on each end will not function normally, however mixing T568A-terminated patch cords with T568B-terminated horizontal cables (or the reverse) will not produce pinout problems in a facility, although it may slightly degrade signal quality, This effect is marginal and certainly no greater than that produced by mixing cable brands in-channel.
T568 A or T568 B- Which One Should I Use?
- If the installation is residential, choose T568A unless other conditions apply (see below).
- If there is pre-existing voice/data wiring (remodel, moves, adds, changes), duplicate this wiring scheme on any new connection.
- If project specifications are available, use the specified wiring configuration.
- If components used within the project are internally wired either T568A or T568B, duplicate this wiring scheme.
T568A and T568B Wiring Assignments:
Wiring Standards
Pin # | T568B | T568A |
1 | White/Orange | White/Green |
2 | Orange | Green |
3 | White/Green | White/Orange |
4 | Blue | Blue |
5 | White/Blue | White/Blue |
6 | Green | Orange |
7 | White/Brown | White/Brown |
8 | Brown | Brown |